| Age | Commit message (Collapse) | Author | Files | Lines |
|---|
|
The added lvds driver and a change in the dsi driver resulted in failed
builds when COMMON_CLK is disabled:
x86_64-linux-ld: drivers/gpu/drm/stm/dw_mipi_dsi-stm.o: in function `dw_mipi_dsi_stm_remove':
dw_mipi_dsi-stm.c:(.text+0x51e): undefined reference to `clk_hw_unregister'
x86_64-linux-ld: drivers/gpu/drm/stm/lvds.o: in function `lvds_remove':
lvds.c:(.text+0xe3): undefined reference to `of_clk_del_provider'
x86_64-linux-ld: lvds.c:(.text+0xec): undefined reference to `clk_hw_unregister'
x86_64-linux-ld: drivers/gpu/drm/stm/lvds.o: in function `lvds_pll_config':
lvds.c:(.text+0xb5d): undefined reference to `clk_hw_get_rate'
x86_64-linux-ld: drivers/gpu/drm/stm/lvds.o: in function `lvds_probe':
lvds.c:(.text+0x1476): undefined reference to `clk_hw_register'
x86_64-linux-ld: lvds.c:(.text+0x148b): undefined reference to `of_clk_hw_simple_get'
x86_64-linux-ld: lvds.c:(.text+0x1493): undefined reference to `of_clk_add_hw_provider'
x86_64-linux-ld: lvds.c:(.text+0x1535): undefined reference to `clk_hw_unregister'
Add this as a dependency for the stm driver itself, since it will be
required in practice anyway.
Fixes: 185f99b61442 ("drm/stm: dsi: expose DSI PHY internal clock")
Fixes: aca1cbc1c986 ("drm/stm: lvds: add new STM32 LVDS Display Interface Transmitter driver")
Signed-off-by: Arnd Bergmann <[email protected]>
Link: https://patchwork.freedesktop.org/patch/msgid/[email protected]
Signed-off-by: Raphael Gallais-Pou <[email protected]>
(cherry picked from commit 26dbffb2a4c4d4639c7b336f6b74a437c23dadd4)
Signed-off-by: Maxime Ripard <[email protected]>
|
|
The Low-Voltage Differential Signaling (LVDS) Display Interface
Transmitter handles the LVDS protocol: it maps the pixels received from
the upstream Pixel-DMA LCD-TFT Display Controller (LTDC) onto the LVDS
PHY.
It is composed of three sub blocks:
* LVDS host: handles the LVDS protocol (FPD / OpenLDI) and maps
its input pixels onto the data lanes of the PHY
* LVDS PHY: parallelize the data and drives the LVDS data lanes
* LVDS wrapper: handles top-level settings
The LVDS controller driver supports the following high-level features:
* FDP-Link-I and OpenLDI (v0.95) protocols
* Single-Link or Dual-Link operation
* Single-Display or Double-Display (with the same content
duplicated on both)
* Flexible Bit-Mapping, including JEIDA and VESA
* RGB888 or RGB666 output
* Synchronous design, with one input pixel per clock cycle
Signed-off-by: Raphael Gallais-Pou <[email protected]>
Acked-by: Yannick Fertre <[email protected]>
Signed-off-by: Philippe Cornu <[email protected]>
Link: https://patchwork.freedesktop.org/patch/msgid/[email protected]
|
|
Allow stm to be built with COMPILE_TEST=y for greater
coverage. Builds fine on x86/x86_64 at least.
Cc: Yannick Fertre <[email protected]>
Cc: Raphael Gallais-Pou <[email protected]>
Cc: Philippe Cornu <[email protected]>
Signed-off-by: Ville Syrjälä <[email protected]>
Link: https://patchwork.freedesktop.org/patch/msgid/[email protected]
Acked-by: Raphaël Gallais-Pou <[email protected]>
|
|
Some of these dependencies used to be sensible when only a small part of
the platforms supported by ARCH=arm could be compiled together in a
single kernel image. Nowadays ARCH_MULTIPLATFORM is only used as a guard
for kernel options incompatible with a multiplatform image. See commit
84fc86360623 ("ARM: make ARCH_MULTIPLATFORM user-visible") for some more
details.
Signed-off-by: Uwe Kleine-König <[email protected]>
Acked-by: Arnd Bergmann <[email protected]>
Reviewed-by: Javier Martinez Canillas <[email protected]>
Reviewed-by: Philipp Zabel <[email protected]>
Signed-off-by: Javier Martinez Canillas <[email protected]>
Link: https://patchwork.freedesktop.org/patch/msgid/[email protected]
|
|
Rename "GEM CMA" helpers to "GEM DMA" helpers - considering the
hierarchy of APIs (mm/cma -> dma -> gem dma) calling them "GEM
DMA" seems to be more applicable.
Besides that, commit e57924d4ae80 ("drm/doc: Task to rename CMA helpers")
requests to rename the CMA helpers and implies that people seem to be
confused about the naming.
In order to do this renaming the following script was used:
```
#!/bin/bash
DIRS="drivers/gpu include/drm Documentation/gpu"
REGEX_SYM_UPPER="[0-9A-Z_\-]"
REGEX_SYM_LOWER="[0-9a-z_\-]"
REGEX_GREP_UPPER="(${REGEX_SYM_UPPER}*)(GEM)_CMA_(${REGEX_SYM_UPPER}*)"
REGEX_GREP_LOWER="(${REGEX_SYM_LOWER}*)(gem)_cma_(${REGEX_SYM_LOWER}*)"
REGEX_SED_UPPER="s/${REGEX_GREP_UPPER}/\1\2_DMA_\3/g"
REGEX_SED_LOWER="s/${REGEX_GREP_LOWER}/\1\2_dma_\3/g"
# Find all upper case 'CMA' symbols and replace them with 'DMA'.
for ff in $(grep -REHl "${REGEX_GREP_UPPER}" $DIRS)
do
sed -i -E "$REGEX_SED_UPPER" $ff
done
# Find all lower case 'cma' symbols and replace them with 'dma'.
for ff in $(grep -REHl "${REGEX_GREP_LOWER}" $DIRS)
do
sed -i -E "$REGEX_SED_LOWER" $ff
done
# Replace all occurrences of 'CMA' / 'cma' in comments and
# documentation files with 'DMA' / 'dma'.
for ff in $(grep -RiHl " cma " $DIRS)
do
sed -i -E "s/ cma / dma /g" $ff
sed -i -E "s/ CMA / DMA /g" $ff
done
# Rename all 'cma_obj's to 'dma_obj'.
for ff in $(grep -RiHl "cma_obj" $DIRS)
do
sed -i -E "s/cma_obj/dma_obj/g" $ff
done
```
Only a few more manual modifications were needed, e.g. reverting the
following modifications in some DRM Kconfig files
- select CMA if HAVE_DMA_CONTIGUOUS
+ select DMA if HAVE_DMA_CONTIGUOUS
as well as manually picking the occurrences of 'CMA'/'cma' in comments and
documentation which relate to "GEM CMA", but not "FB CMA".
Also drivers/gpu/drm/Makefile was fixed up manually after renaming
drm_gem_cma_helper.c to drm_gem_dma_helper.c.
This patch is compile-time tested building a x86_64 kernel with
`make allyesconfig && make drivers/gpu/drm`.
Acked-by: Sam Ravnborg <[email protected]>
Acked-by: Thomas Zimmermann <[email protected]>
Reviewed-by: Laurent Pinchart <[email protected]>
Signed-off-by: Danilo Krummrich <[email protected]>
Reviewed-by: Liviu Dudau <[email protected]> #drivers/gpu/drm/arm
Signed-off-by: Sam Ravnborg <[email protected]>
Link: https://patchwork.freedesktop.org/patch/msgid/[email protected]
|
|
Link drm_fb_cma_helper.o into drm_cma_helper.ko if CONFIG_DRM_KMS_HELPER
has been set. Remove CONFIG_DRM_KMS_CMA_HELPER config option. Selecting
KMS helpers and CMA will now automatically enable CMA KMS helpers.
Some drivers' Kconfig files did not correctly select KMS or CMA helpers.
Fix this as part of the change.
Signed-off-by: Thomas Zimmermann <[email protected]>
Reviewed-by: Daniel Vetter <[email protected]>
Link: https://patchwork.freedesktop.org/patch/msgid/[email protected]
|
|
Add SPDX license identifiers to all Make/Kconfig files which:
- Have no license information of any form
These files fall under the project license, GPL v2 only. The resulting SPDX
license identifier is:
GPL-2.0-only
Signed-off-by: Thomas Gleixner <[email protected]>
Signed-off-by: Greg Kroah-Hartman <[email protected]>
|
|
The DRM_STM driver can be built independently of the framebuffer
layer, but it causes a Kconfig warning:
WARNING: unmet direct dependencies detected for FB_PROVIDE_GET_FB_UNMAPPED_AREA
Depends on [n]: HAS_IOMEM [=y] && FB [=n]
Selected by [y]:
- DRM_STM [=y] && HAS_IOMEM [=y] && DRM [=y] && (ARCH_STM32 [=n] || ARCH_MULTIPLATFORM [=y])
Selecting FB_PROVIDE_GET_FB_UNMAPPED_AREA actually has no effect
if CONFIG_FB is disabled, so we can make it a conditional 'select'
instead.
Signed-off-by: Arnd Bergmann <[email protected]>
Signed-off-by: Benjamin Gaignard <[email protected]>
Link: https://patchwork.freedesktop.org/patch/msgid/[email protected]
|
|
To do not force stm driver to be build by default
Signed-off-by: Benjamin Gaignard <[email protected]>
Reviewed-by: Emil Velikov <[email protected]>
Link: https://patchwork.freedesktop.org/patch/msgid/[email protected]
|
|
Add the STM32 DSI controller driver that uses the Synopsys DesignWare
MIPI DSI host controller bridge.
Signed-off-by: Philippe CORNU <[email protected]>
Reviewed-by: Neil Armstrong <[email protected]>
Reviewed-by: Archit Taneja <[email protected]>
Signed-off-by: Benjamin Gaignard <[email protected]>
Link: https://patchwork.freedesktop.org/patch/msgid/[email protected]
|
|
Add the panel-bridge support for both panels & bridges (used by DSI host &
HDMI/LVDS bridges).
Signed-off-by: Philippe CORNU <[email protected]>
Reviewed-by: Archit Taneja <[email protected]>
Signed-off-by: Archit Taneja <[email protected]>
Link: https://patchwork.freedesktop.org/patch/msgid/[email protected]
|
|
This controller provides output signals to interface directly a variety
of LCD and TFT panels. These output signals are: RGB signals
(up to 24bpp), vertical & horizontal synchronisations, data enable and
the pixel clock.
Reviewed-by: Eric Anholt <[email protected]>
Signed-off-by: Yannick Fertre <[email protected]>
Signed-off-by: Eric Anholt <[email protected]>
Link: http://patchwork.freedesktop.org/patch/msgid/[email protected]
Reviewed-by: Neil Armstrong <[email protected]>
Reviewed-by: Eric Anholt <[email protected]>
|