diff options
| -rw-r--r-- | arch/arm64/boot/dts/qcom/sc7180-idp.dts | 10 |
1 files changed, 4 insertions, 6 deletions
diff --git a/arch/arm64/boot/dts/qcom/sc7180-idp.dts b/arch/arm64/boot/dts/qcom/sc7180-idp.dts index d033b3aad54e..cd8e6fa3301d 100644 --- a/arch/arm64/boot/dts/qcom/sc7180-idp.dts +++ b/arch/arm64/boot/dts/qcom/sc7180-idp.dts @@ -473,32 +473,30 @@ &qup_uart3_default { pinconf-cts { /* - * Configure a pull-down on 38 (CTS) to match the pull of + * Configure a pull-down on CTS to match the pull of * the Bluetooth module. */ pins = "gpio38"; bias-pull-down; - output-high; }; pinconf-rts { - /* We'll drive 39 (RTS), so no pull */ + /* We'll drive RTS, so no pull */ pins = "gpio39"; drive-strength = <2>; bias-disable; }; pinconf-tx { - /* We'll drive 40 (TX), so no pull */ + /* We'll drive TX, so no pull */ pins = "gpio40"; drive-strength = <2>; bias-disable; - output-high; }; pinconf-rx { /* - * Configure a pull-up on 41 (RX). This is needed to avoid + * Configure a pull-up on RX. This is needed to avoid * garbage data when the TX pin of the Bluetooth module is * in tri-state (module powered off or not driving the * signal yet). |