diff options
| -rw-r--r-- | drivers/gpu/drm/msm/dp/dp_display.c | 71 | ||||
| -rw-r--r-- | drivers/gpu/drm/msm/dp/dp_display.h | 1 | ||||
| -rw-r--r-- | drivers/gpu/drm/msm/dp/dp_drm.c | 21 | ||||
| -rw-r--r-- | drivers/gpu/drm/msm/dp/dp_parser.c | 23 | ||||
| -rw-r--r-- | drivers/gpu/drm/msm/dp/dp_parser.h | 14 |
5 files changed, 101 insertions, 29 deletions
diff --git a/drivers/gpu/drm/msm/dp/dp_display.c b/drivers/gpu/drm/msm/dp/dp_display.c index b37bc1c74d88..b99f918d90f3 100644 --- a/drivers/gpu/drm/msm/dp/dp_display.c +++ b/drivers/gpu/drm/msm/dp/dp_display.c @@ -10,6 +10,7 @@ #include <linux/component.h> #include <linux/of_irq.h> #include <linux/delay.h> +#include <drm/dp/drm_dp_aux_bus.h> #include "msm_drv.h" #include "msm_kms.h" @@ -263,13 +264,12 @@ static int dp_display_bind(struct device *dev, struct device *master, dp->dp_display.drm_dev = drm; priv->dp[dp->id] = &dp->dp_display; - rc = dp->parser->parse(dp->parser, dp->dp_display.connector_type); + rc = dp->parser->parse(dp->parser); if (rc) { DRM_ERROR("device tree parsing failed\n"); goto end; } - dp->dp_display.next_bridge = dp->parser->next_bridge; dp->drm_dev = drm; dp->aux->drm_dev = drm; @@ -1288,6 +1288,8 @@ static int dp_display_probe(struct platform_device *pdev) dp->name = "drm_dp"; dp->dp_display.connector_type = desc->connector_type; dp->wide_bus_en = desc->wide_bus_en; + dp->dp_display.is_edp = + (dp->dp_display.connector_type == DRM_MODE_CONNECTOR_eDP); rc = dp_init_sub_modules(dp); if (rc) { @@ -1481,7 +1483,8 @@ void msm_dp_irq_postinstall(struct msm_dp *dp_display) dp = container_of(dp_display, struct dp_display_private, dp_display); - dp_add_event(dp, EV_HPD_INIT_SETUP, 0, 100); + if (!dp_display->is_edp) + dp_add_event(dp, EV_HPD_INIT_SETUP, 0, 100); } bool msm_dp_wide_bus_available(const struct msm_dp *dp_display) @@ -1512,6 +1515,64 @@ void msm_dp_debugfs_init(struct msm_dp *dp_display, struct drm_minor *minor) } } +static int dp_display_get_next_bridge(struct msm_dp *dp) +{ + int rc; + struct dp_display_private *dp_priv; + struct device_node *aux_bus; + struct device *dev; + + dp_priv = container_of(dp, struct dp_display_private, dp_display); + dev = &dp_priv->pdev->dev; + aux_bus = of_get_child_by_name(dev->of_node, "aux-bus"); + + if (aux_bus && dp->is_edp) { + dp_display_host_init(dp_priv); + dp_catalog_ctrl_hpd_config(dp_priv->catalog); + dp_display_host_phy_init(dp_priv); + enable_irq(dp_priv->irq); + + /* + * The code below assumes that the panel will finish probing + * by the time devm_of_dp_aux_populate_ep_devices() returns. + * This isn't a great assumption since it will fail if the + * panel driver is probed asynchronously but is the best we + * can do without a bigger driver reorganization. + */ + rc = devm_of_dp_aux_populate_ep_devices(dp_priv->aux); + of_node_put(aux_bus); + if (rc) + goto error; + } else if (dp->is_edp) { + DRM_ERROR("eDP aux_bus not found\n"); + return -ENODEV; + } + + /* + * External bridges are mandatory for eDP interfaces: one has to + * provide at least an eDP panel (which gets wrapped into panel-bridge). + * + * For DisplayPort interfaces external bridges are optional, so + * silently ignore an error if one is not present (-ENODEV). + */ + rc = dp_parser_find_next_bridge(dp_priv->parser); + if (!dp->is_edp && rc == -ENODEV) + return 0; + + if (!rc) { + dp->next_bridge = dp_priv->parser->next_bridge; + return 0; + } + +error: + if (dp->is_edp) { + disable_irq(dp_priv->irq); + dp_display_host_phy_exit(dp_priv); + dp_display_host_deinit(dp_priv); + } + return rc; +} + int msm_dp_modeset_init(struct msm_dp *dp_display, struct drm_device *dev, struct drm_encoder *encoder) { @@ -1535,6 +1596,10 @@ int msm_dp_modeset_init(struct msm_dp *dp_display, struct drm_device *dev, dp_display->encoder = encoder; + ret = dp_display_get_next_bridge(dp_display); + if (ret) + return ret; + dp_display->bridge = dp_bridge_init(dp_display, dev, encoder); if (IS_ERR(dp_display->bridge)) { ret = PTR_ERR(dp_display->bridge); diff --git a/drivers/gpu/drm/msm/dp/dp_display.h b/drivers/gpu/drm/msm/dp/dp_display.h index f1adf2b84975..4f9fe4d7610b 100644 --- a/drivers/gpu/drm/msm/dp/dp_display.h +++ b/drivers/gpu/drm/msm/dp/dp_display.h @@ -21,6 +21,7 @@ struct msm_dp { bool audio_enabled; bool power_on; unsigned int connector_type; + bool is_edp; hdmi_codec_plugged_cb plugged_cb; diff --git a/drivers/gpu/drm/msm/dp/dp_drm.c b/drivers/gpu/drm/msm/dp/dp_drm.c index 5f6658ebd737..62d58b9c4647 100644 --- a/drivers/gpu/drm/msm/dp/dp_drm.c +++ b/drivers/gpu/drm/msm/dp/dp_drm.c @@ -87,10 +87,23 @@ struct drm_bridge *dp_bridge_init(struct msm_dp *dp_display, struct drm_device * bridge->funcs = &dp_bridge_ops; bridge->type = dp_display->connector_type; - bridge->ops = - DRM_BRIDGE_OP_DETECT | - DRM_BRIDGE_OP_HPD | - DRM_BRIDGE_OP_MODES; + /* + * Many ops only make sense for DP. Why? + * - Detect/HPD are used by DRM to know if a display is _physically_ + * there, not whether the display is powered on / finished initting. + * On eDP we assume the display is always there because you can't + * know until power is applied. If we don't implement the ops DRM will + * assume our display is always there. + * - Currently eDP mode reading is driven by the panel driver. This + * allows the panel driver to properly power itself on to read the + * modes. + */ + if (!dp_display->is_edp) { + bridge->ops = + DRM_BRIDGE_OP_DETECT | + DRM_BRIDGE_OP_HPD | + DRM_BRIDGE_OP_MODES; + } drm_bridge_add(bridge); diff --git a/drivers/gpu/drm/msm/dp/dp_parser.c b/drivers/gpu/drm/msm/dp/dp_parser.c index 8ad587f7b8d3..8f9fed9fdafc 100644 --- a/drivers/gpu/drm/msm/dp/dp_parser.c +++ b/drivers/gpu/drm/msm/dp/dp_parser.c @@ -263,7 +263,7 @@ static int dp_parser_clock(struct dp_parser *parser) return 0; } -static int dp_parser_find_next_bridge(struct dp_parser *parser) +int dp_parser_find_next_bridge(struct dp_parser *parser) { struct device *dev = &parser->pdev->dev; struct drm_bridge *bridge; @@ -277,7 +277,7 @@ static int dp_parser_find_next_bridge(struct dp_parser *parser) return 0; } -static int dp_parser_parse(struct dp_parser *parser, int connector_type) +static int dp_parser_parse(struct dp_parser *parser) { int rc = 0; @@ -298,25 +298,6 @@ static int dp_parser_parse(struct dp_parser *parser, int connector_type) if (rc) return rc; - /* - * External bridges are mandatory for eDP interfaces: one has to - * provide at least an eDP panel (which gets wrapped into panel-bridge). - * - * For DisplayPort interfaces external bridges are optional, so - * silently ignore an error if one is not present (-ENODEV). - */ - rc = dp_parser_find_next_bridge(parser); - if (rc == -ENODEV) { - if (connector_type == DRM_MODE_CONNECTOR_eDP) { - DRM_ERROR("eDP: next bridge is not present\n"); - return rc; - } - } else if (rc) { - if (rc != -EPROBE_DEFER) - DRM_ERROR("DP: error parsing next bridge: %d\n", rc); - return rc; - } - /* Map the corresponding regulator information according to * version. Currently, since we only have one supported platform, * mapping the regulator directly. diff --git a/drivers/gpu/drm/msm/dp/dp_parser.h b/drivers/gpu/drm/msm/dp/dp_parser.h index d371bae1c968..3a4d7972c069 100644 --- a/drivers/gpu/drm/msm/dp/dp_parser.h +++ b/drivers/gpu/drm/msm/dp/dp_parser.h @@ -125,7 +125,7 @@ struct dp_parser { u32 max_dp_lanes; struct drm_bridge *next_bridge; - int (*parse)(struct dp_parser *parser, int connector_type); + int (*parse)(struct dp_parser *parser); }; /** @@ -141,4 +141,16 @@ struct dp_parser { */ struct dp_parser *dp_parser_get(struct platform_device *pdev); +/** + * dp_parser_find_next_bridge() - find an additional bridge to DP + * + * @parser: dp_parser data from client + * + * This function is used to find any additional bridge attached to + * the DP controller. The eDP interface requires a panel bridge. + * + * Return: 0 if able to get the bridge, otherwise negative errno for failure. + */ +int dp_parser_find_next_bridge(struct dp_parser *parser); + #endif |