i40e: Report MFS in decimal base instead of hex

If the MFS is set below the default (0x2600), a warning message is
reported like the following :

	MFS for port 1 has been set below the default: 600

This message is a bit confusing as the number shown here (600) is in
fact an hexa number: 0x600 = 1536

Without any explicit "0x" prefix, this message is read like the MFS is
set to 600 bytes.

MFS, as per MTUs, are usually expressed in decimal base.

This commit reports both current and default MFS values in decimal
so it's less confusing for end-users.

A typical warning message looks like the following :

	MFS for port 1 (1536) has been set below the default (9728)

Signed-off-by: Erwan Velu <[email protected]>
Reviewed-by: Simon Horman <[email protected]>
Tested-by: Tony Brelinski <[email protected]>
Signed-off-by: Tony Nguyen <[email protected]>
Fixes: 3a2c6ced90e1 ("i40e: Add a check to see if MFS is set")
Link: https://lore.kernel.org/r/[email protected]
Signed-off-by: Jakub Kicinski <[email protected]>

0 files changed, 0 insertions, 0 deletions