i2c: bcm2835: Can't support I2C_M_IGNORE_NAK

The controller can't support this flag, so remove it.

Documentation/i2c/i2c-protocol states that all of the message is sent:

I2C_M_IGNORE_NAK:
    Normally message is interrupted immediately if there is [NA] from the
    client. Setting this flag treats any [NA] as [A], and all of
    message is sent.

>From the BCM2835 ARM Peripherals datasheet:

    The ERR field is set when the slave fails to acknowledge either
    its address or a data byte written to it.

So when the controller doesn't receive an ack, it sets ERR and raises
an interrupt. In other words, the whole message is not sent.

Signed-off-by: Noralf Trønnes <[email protected]>
Reviewed-by: Eric Anholt <[email protected]>
Signed-off-by: Wolfram Sang <[email protected]>

0 files changed, 0 insertions, 0 deletions