drm: bridge: samsung-dsim: Support non-burst mode

The high-speed clock is hard-coded to the burst-clock
frequency specified in the device tree.  However, when
using devices like certain bridge chips without burst mode
and varying resolutions and refresh rates, it may be
necessary to set the high-speed clock dynamically based
on the desired pixel clock for the connected device.

This also removes the need to set a clock speed from
the device tree for non-burst mode operation, since the
pixel clock rate is the rate requested from the attached
device like a bridge chip.  This should have no impact
for people using burst-mode and setting the burst clock
rate is still required for those users.  If the burst
clock is not present, change the error message to
dev_info indicating the clock use the pixel clock.

Signed-off-by: Adam Ford <[email protected]>
Tested-by: Chen-Yu Tsai <[email protected]>
Tested-by: Frieder Schrempf <[email protected]>
Reviewed-by: Frieder Schrempf <[email protected]>
Tested-by: Marek Szyprowski <[email protected]>
Reviewed-by: Jagan Teki <[email protected]>
Tested-by: Jagan Teki <[email protected]> # imx8mm-icore
Signed-off-by: Neil Armstrong <[email protected]>
Link: https://patchwork.freedesktop.org/patch/msgid/[email protected]

0 files changed, 0 insertions, 0 deletions