net: phy: realtek: configure SerDes mode for rtl822xb PHYs

The rtl8221b and rtl8226b series support switching SerDes mode between
2500base-x and sgmii based on the negotiated copper speed.

Configure this switching mode according to SerDes modes supported by
host.

There is an additional datasheet for RTL8226B/RTL8221B called
"SERDES MODE SETTING FLOW APPLICATION NOTE" where a sequence is
described to setup interface and rate adapter mode.

However, there is no documentation about the meaning of registers
and bits, it's literally just magic numbers and pseudo-code.

Signed-off-by: Alexander Couzens <[email protected]>
[ refactored, dropped HiSGMII mode and changed commit message ]
Signed-off-by: Marek Behún <[email protected]>
[ changed rtl822x_update_interface() to use vendor register ]
[ always fill in possible interfaces ]
[ only apply to rtl8221b and rtl8226b phy's ]
[ set phydev->rate_matching in .config_init() ]
Signed-off-by: Eric Woudstra <[email protected]>

Reviewed-by: Russell King (Oracle) <[email protected]>
Reviewed-by: should come before them, without any blank lines. As the
Signed-off-by: David S. Miller <[email protected]>

0 files changed, 0 insertions, 0 deletions