ibmvnic: Only record tx completed bytes once per handler

Byte Queue Limits depends on dql_completed being called once per tx
completion round in order to adjust its algorithm appropriately. The
dql->limit value is an approximation of the amount of bytes that the NIC
can consume per irq interval. If this approximation is too high then the
NIC will become over-saturated. Too low and the NIC will starve.

The dql->limit depends on dql->prev-* stats to calculate an optimal
value. If dql_completed() is called more than once per irq handler then
those prev-* values become unreliable (because they are not an accurate
representation of the previous state of the NIC) resulting in a
sub-optimal limit value.

Therefore, move the call to netdev_tx_completed_queue() to the end of
ibmvnic_complete_tx().

When performing 150 sessions of TCP rr (request-response 1 byte packets)
workloads, one could observe:
  PREVIOUSLY: - limit and inflight values hovering around 130
              - transaction rate of around 750k pps.

  NOW:        - limit rises and falls in response to inflight (130-900)
              - transaction rate of around 1M pps (33% improvement)

Signed-off-by: Nick Child <[email protected]>
Link: https://patch.msgid.link/[email protected]
Signed-off-by: Jakub Kicinski <[email protected]>

0 files changed, 0 insertions, 0 deletions