riscv: dts: starfive: visionfive-v1: Setup ethernet phy

The StarFive VisionFive V1 SBC uses a Motorcomm YT8521 PHY supporting
RGMII-ID, but requires manual adjustment of the RX internal delay to
work properly.

The default RX delay provided by the driver is 1.95 ns, which proves to
be too high. Applying a 50% reduction seems to mitigate the issue.

Also note this adjustment is not necessary on BeagleV Starlight SBC,
which uses a Microchip PHY.  Hence, there is no indication of a
misbehaviour on the GMAC side, but most likely the issue stems from
the Motorcomm PHY.

While at it, drop the redundant gpio include, which is already provided
by jh7100-common.dtsi.

Co-developed-by: Emil Renner Berthing <[email protected]>
Signed-off-by: Emil Renner Berthing <[email protected]>
Signed-off-by: Cristian Ciocaltea <[email protected]>
Reviewed-by: Jacob Keller <[email protected]>
Reviewed-by: Andrew Lunn <[email protected]>
Reviewed-by: Emil Renner Berthing <[email protected]>
Signed-off-by: Conor Dooley <[email protected]>

0 files changed, 0 insertions, 0 deletions