phy: mapphone-mdm6600: Improve phy related runtime PM calls

I noticed that phy_pm_runtime_get_sync() and phy_pm_runtime_put() are not
currently doing anything for phy-mapphone-mdm6600, only the sysfs interface
for works for "auto" and "on".

This is because of the shared GPIO pins between mdm6600 USB port and n_gsm
port. We have not enabled runtime PM for the phy driver until after we've
booted up mdm6600 properly to the USB mode. Otherwise phy_create() would
have called pm_runtime_enable() and pm_runtime_no_callbacks() automatically
on init.

Let's fix this by registering the phy a bit later after we've powered up
the mdm6600 USB port.

And as the PM runtime support is only needed for the n_gsm mode and not for
USB, we can allow the device to idle between phy_mdm6600_power_on() and
phy_mdm6600_power_off(). Note that for suspend, runtime_pm is already
disabled for the phy so we need to check for pm_runtime_enabled().

Cc: Johan Hovold <[email protected]>
Cc: Pavel Machek <[email protected]>
Cc: Sebastian Reichel <[email protected]>
Signed-off-by: Tony Lindgren <[email protected]>
Signed-off-by: Kishon Vijay Abraham I <[email protected]>

0 files changed, 0 insertions, 0 deletions