clockevents/drivers/timer-sp804: Migrate to new 'set-state' interface

Migrate timer-sp driver to the new 'set-state' interface provided by
clockevents core, the earlier 'set-mode' interface is marked obsolete
now.

This also enables us to implement callbacks for new states of clockevent
devices, for example: ONESHOT_STOPPED.

There are few more changes worth noticing:

- The clockevent device was disabled by writing: 'TIMER_CTRL_32BIT |
  TIMER_CTRL_IE' to ctrl register earlier. i.e. by un-setting the
  TIMER_CTRL_ENABLE bit. Its done by writing zero now and should have
  the same effect.

- For shutdown and resume we were writing the same value twice to the
  register (to disable the timer), which is fixed now.

- Switching to oneshot mode was divided into two parts earlier:
  - Firstly set_mode() was writing:
    'TIMER_CTRL_32BIT | TIMER_CTRL_IE | TIMER_CTRL_ONESHOT'
    to ctrl register (device not enabled yet)
  - Then sp804_set_next_event() was enabling the device by writing
    'readl(ctrl) | TIMER_CTRL_ENABLE' to the ctrl register. This was
    unnecessarily complicated.
  - Change this to: Stop device on set_state_oneshot and configure it in
    sp804_set_next_event().

Cc: Daniel Lezcano <[email protected]>
Cc: Russell King <[email protected]>
Cc: Sudeep Holla <[email protected]>
Cc: Arnd Bergmann <[email protected]>
Cc: Catalin Marinas <[email protected]>
Cc: Olof Johansson <[email protected]>
Signed-off-by: Viresh Kumar <[email protected]>
Signed-off-by: Daniel Lezcano <[email protected]>

0 files changed, 0 insertions, 0 deletions