x86/apic: Clear stale x2apic mode

If x2apic got disabled on the kernel command line, then the following
issue can happen:

enable_IR_x2apic()
   ....
   x2apic_mode = 1;
   enable_x2apic();

     if (x2apic_disabled) {
	__disable_x2apic();
	return;
     }

That leaves X2APIC disabled in hardware, but x2apic_mode stays 1. So
all other code which checks x2apic_mode gets the wrong information.

Set x2apic_mode to 0 after disabling it in hardware.

This is just a hotfix. The proper solution is to rework this code so
it has seperate functions for the initial setup on the boot processor
and the secondary cpus, but that's beyond the scope of this fix.

Signed-off-by: Thomas Gleixner <[email protected]>
Cc: Jiang Liu <[email protected]>
Cc: Tony Luck <[email protected]>
Cc: [email protected]
Cc: H. Peter Anvin <[email protected]>
Cc: Joerg Roedel <[email protected]>
Cc: Benjamin Herrenschmidt <[email protected]>
Cc: Yinghai Lu <[email protected]>
Cc: Borislav Petkov <[email protected]>
Cc: David Rientjes <[email protected]>
Cc: HATAYAMA Daisuke <[email protected]>
Cc: Jan Beulich <[email protected]>
Cc: Richard Weinberger <[email protected]>
Cc: Oren Twaig <[email protected]>

0 files changed, 0 insertions, 0 deletions