Merge branch 'upstream-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/jgarzik/libata-dev

* 'upstream-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/jgarzik/libata-dev: (49 commits)
  libata-sff: separate out BMDMA qc_issue
  libata-sff: prd is BMDMA specific
  libata-sff: ata_sff_[dumb_]qc_prep are BMDMA specific
  libata-sff: separate out BMDMA EH
  libata-sff: port_task is SFF specific
  libata-sff: ap->[last_]ctl are SFF specific
  libata-sff: rename ap->ops->drain_fifo() to sff_drain_fifo()
  libata-sff: introduce ata_sff_init/exit() and ata_sff_port_init()
  libata-sff: clean up BMDMA initialization
  libata-sff: clean up inheritance in several drivers
  libata-sff: reorder SFF/BMDMA functions
  sata_inic162x: kill PORT_PRD_ADDR initialization
  libata: kill ATA_FLAG_DISABLED
  libata-sff: kill unused prototype and make ata_dev_select() static
  libata-sff: update bmdma host bus error handling
  sata_mv: remove unnecessary initialization
  sata_inic162x: inic162x is not dependent on CONFIG_ATA_SFF
  pata_sch: use ata_pci_sff_init_one()
  pata_sil680: Do our own exec_command posting
  libata: Remove excess delay in the tf_load path
  ...

1 files changed, 20 insertions, 60 deletions

diff --git a/drivers/ata/pata_scc.c b/drivers/ata/pata_scc.c
index 4257d6b40af4..6f6193b707cb 100644
--- a/drivers/ata/pata_scc.c
+++ b/drivers/ata/pata_scc.c
@@ -265,7 +265,7 @@ unsigned long scc_mode_filter(struct ata_device *adev, unsigned long mask)
 		printk(KERN_INFO "%s: limit ATAPI UDMA to UDMA4\n", DRV_NAME);
 		mask &= ~(0xE0 << ATA_SHIFT_UDMA);
 	}
-	return ata_bmdma_mode_filter(adev, mask);
+	return mask;
 }
 
 /**
@@ -416,6 +416,17 @@ static void scc_dev_select (struct ata_port *ap, unsigned int device)
 }
 
 /**
+ *	scc_set_devctl - Write device control reg
+ *	@ap: port where the device is
+ *	@ctl: value to write
+ */
+
+static void scc_set_devctl(struct ata_port *ap, u8 ctl)
+{
+	out_be32(ap->ioaddr.ctl_addr, ctl);
+}
+
+/**
  *	scc_bmdma_setup - Set up PCI IDE BMDMA transaction
  *	@qc: Info associated with this ATA transaction.
  *
@@ -430,7 +441,7 @@ static void scc_bmdma_setup (struct ata_queued_cmd *qc)
 	void __iomem *mmio = ap->ioaddr.bmdma_addr;
 
 	/* load PRD table addr */
-	out_be32(mmio + SCC_DMA_TABLE_OFS, ap->prd_dma);
+	out_be32(mmio + SCC_DMA_TABLE_OFS, ap->bmdma_prd_dma);
 
 	/* specify data direction, triple-check start bit is clear */
 	dmactl = in_be32(mmio + SCC_DMA_CMD);
@@ -501,8 +512,8 @@ static unsigned int scc_devchk (struct ata_port *ap,
  *	Note: Original code is ata_sff_wait_after_reset
  */
 
-int scc_wait_after_reset(struct ata_link *link, unsigned int devmask,
-			 unsigned long deadline)
+static int scc_wait_after_reset(struct ata_link *link, unsigned int devmask,
+				unsigned long deadline)
 {
 	struct ata_port *ap = link->ap;
 	struct ata_ioports *ioaddr = &ap->ioaddr;
@@ -817,54 +828,6 @@ static unsigned int scc_data_xfer (struct ata_device *dev, unsigned char *buf,
 }
 
 /**
- *	scc_irq_on - Enable interrupts on a port.
- *	@ap: Port on which interrupts are enabled.
- *
- *	Note: Original code is ata_sff_irq_on().
- */
-
-static u8 scc_irq_on (struct ata_port *ap)
-{
-	struct ata_ioports *ioaddr = &ap->ioaddr;
-	u8 tmp;
-
-	ap->ctl &= ~ATA_NIEN;
-	ap->last_ctl = ap->ctl;
-
-	out_be32(ioaddr->ctl_addr, ap->ctl);
-	tmp = ata_wait_idle(ap);
-
-	ap->ops->sff_irq_clear(ap);
-
-	return tmp;
-}
-
-/**
- *	scc_freeze - Freeze BMDMA controller port
- *	@ap: port to freeze
- *
- *	Note: Original code is ata_sff_freeze().
- */
-
-static void scc_freeze (struct ata_port *ap)
-{
-	struct ata_ioports *ioaddr = &ap->ioaddr;
-
-	ap->ctl |= ATA_NIEN;
-	ap->last_ctl = ap->ctl;
-
-	out_be32(ioaddr->ctl_addr, ap->ctl);
-
-	/* Under certain circumstances, some controllers raise IRQ on
-	 * ATA_NIEN manipulation.  Also, many controllers fail to mask
-	 * previously pending IRQ on ATA_NIEN assertion.  Clear it.
-	 */
-	ap->ops->sff_check_status(ap);
-
-	ap->ops->sff_irq_clear(ap);
-}
-
-/**
  *	scc_pata_prereset - prepare for reset
  *	@ap: ATA port to be reset
  *	@deadline: deadline jiffies for the operation
@@ -903,8 +866,7 @@ static void scc_postreset(struct ata_link *link, unsigned int *classes)
 	}
 
 	/* set up device control */
-	if (ap->ioaddr.ctl_addr)
-		out_be32(ap->ioaddr.ctl_addr, ap->ctl);
+	out_be32(ap->ioaddr.ctl_addr, ap->ctl);
 
 	DPRINTK("EXIT\n");
 }
@@ -930,7 +892,7 @@ static void scc_irq_clear (struct ata_port *ap)
  *	scc_port_start - Set port up for dma.
  *	@ap: Port to initialize
  *
- *	Allocate space for PRD table using ata_port_start().
+ *	Allocate space for PRD table using ata_bmdma_port_start().
  *	Set PRD table address for PTERADD. (PRD Transfer End Read)
  */
 
@@ -939,11 +901,11 @@ static int scc_port_start (struct ata_port *ap)
 	void __iomem *mmio = ap->ioaddr.bmdma_addr;
 	int rc;
 
-	rc = ata_port_start(ap);
+	rc = ata_bmdma_port_start(ap);
 	if (rc)
 		return rc;
 
-	out_be32(mmio + SCC_DMA_PTERADD, ap->prd_dma);
+	out_be32(mmio + SCC_DMA_PTERADD, ap->bmdma_prd_dma);
 	return 0;
 }
 
@@ -978,6 +940,7 @@ static struct ata_port_operations scc_pata_ops = {
 	.sff_check_status	= scc_check_status,
 	.sff_check_altstatus	= scc_check_altstatus,
 	.sff_dev_select		= scc_dev_select,
+	.sff_set_devctl		= scc_set_devctl,
 
 	.bmdma_setup		= scc_bmdma_setup,
 	.bmdma_start		= scc_bmdma_start,
@@ -985,14 +948,11 @@ static struct ata_port_operations scc_pata_ops = {
 	.bmdma_status		= scc_bmdma_status,
 	.sff_data_xfer		= scc_data_xfer,
 
-	.freeze			= scc_freeze,
 	.prereset		= scc_pata_prereset,
 	.softreset		= scc_softreset,
 	.postreset		= scc_postreset,
-	.post_internal_cmd	= scc_bmdma_stop,
 
 	.sff_irq_clear		= scc_irq_clear,
-	.sff_irq_on		= scc_irq_on,
 
 	.port_start		= scc_port_start,
 	.port_stop		= scc_port_stop,