| Age | Commit message (Collapse) | Author | Files | Lines |
|---|
|
USB2.0 PHY hangs in Rx Compliance test when the incoming packet
amplitude is varied below and above the Squelch Level of
Receiver during the active packet multiple times.
Version 1 of the controller allows PHY to be reset when RX fail condition
is detected to work around the above issue. This feature is
disabled by default and needs to be enabled using a bit from
the newly added PHYRST_CFG register. This patch enables the workaround.
There is no way to know controller version before device controller
is started and the workaround needs to be applied for both host and
device modes, so we rely on a DT property do decide when to
apply the workaround.
Signed-off-by: Pawel Laszczak <[email protected]>
Signed-off-by: Roger Quadros <[email protected]>
Signed-off-by: Felipe Balbi <[email protected]>
|
|
Introduce runtime PM and wakeup interrupt handler for cdns3,
the runtime PM is default off since other cdns3 may not
implement glue layer support for runtime PM.
One typical wakeup event use case is xHCI runtime suspend will clear
USBCMD.RS bit, after that the xHCI will not trigger any interrupts,
so its parent (cdns core device) needs to resume xHCI device when
any (wakeup) events occurs at host port.
When the controller is in low power mode, the lpm flag will be set.
The interrupt triggered later than lpm flag is set considers as
wakeup interrupt and handled at cdns_wakeup_irq. Once the wakeup
occurs, it first disables interrupt to avoid later interrupt
occurrence since the controller is in low power mode at that
time, and access registers may be invalid at that time. At wakeup
handler, it will call pm_request_resume to wakeup xHCI device, and
at runtime resume handler, it will enable interrupt again.
The API platform_suspend is introduced for glue layer to implement
platform specific PM sequence.
Reviewed-by: Pawel Laszczak <[email protected]>
Signed-off-by: Peter Chen <[email protected]>
Signed-off-by: Felipe Balbi <[email protected]>
|
|
In short, we have three kinds of role switches:
- Based on SoC: ID and VBUS
- Based on external connnctor, eg, Type-C or GPIO Connector
- Based on user choices through sysfs
Since HW handling and usb-role-switch handling are at
different places, we do not need role_override any more,
and this flag could not judge external connector case well.
With role_override deleted, We use cdns3_hw_role_switch for
the 1st use case, and usb-role-switch for the 2nd and 3rd cases.
Signed-off-by: Peter Chen <[email protected]>
Reviewed-by: Roger Quadros <[email protected]>
Link: https://lore.kernel.org/r/[email protected]
Signed-off-by: Greg Kroah-Hartman <[email protected]>
|
|
This patch introduce new Cadence USBSS DRD driver to Linux kernel.
The Cadence USBSS DRD Controller is a highly configurable IP Core which
can be instantiated as Dual-Role Device (DRD), Peripheral Only and
Host Only (XHCI)configurations.
The current driver has been validated with FPGA platform. We have
support for PCIe bus, which is used on FPGA prototyping.
The host side of USBSS-DRD controller is compliant with XHCI
specification, so it works with standard XHCI Linux driver.
Signed-off-by: Pawel Laszczak <[email protected]>
Signed-off-by: Felipe Balbi <[email protected]>
|