| Age | Commit message (Collapse) | Author | Files | Lines |
|---|
|
It's hard for occasional GPIO code reader/writer to know if values 0/1
equal to IN or OUT. Use defined GPIO_LINE_DIRECTION_IN and
GPIO_LINE_DIRECTION_OUT to help them out.
NOTE - for gpio-amd-fch and gpio-bd9571mwv:
This commit also changes the return value for direction get to equal 1
for direction INPUT. Prior this commit these drivers might have
returned some other positive value but 1 for INPUT.
Signed-off-by: Matti Vaittinen <[email protected]>
Acked-by: Scott Branden <[email protected]>
Reviewed-by: Grygorii Strashko <[email protected]>
Reviewed-by: Michal Simek <[email protected]>
Reviewed-by: Geert Uytterhoeven <[email protected]>
Acked-by: Andy Shevchenko <[email protected]>
Acked-by: William Breathitt Gray <[email protected]>
Acked-by: Kuppuswamy Sathyanarayanan <[email protected]>
Signed-off-by: Linus Walleij <[email protected]>
|
|
These structures are only used to copy into other structures, so declare
them as const.
The semantic patch that makes this change is as follows:
(http://coccinelle.lip6.fr/)
// <smpl>
@r disable optional_qualifier@
identifier i;
position p;
@@
static struct gpio_chip i@p = { ... };
@ok@
identifier r.i;
expression e;
position p;
@@
e = i@p;
@bad@
position p != {r.p,ok.p};
identifier r.i;
struct gpio_chip e;
@@
e@i@p
@depends on !bad disable optional_qualifier@
identifier r.i;
@@
static
+const
struct gpio_chip i = { ... };
// </smpl>
Signed-off-by: Julia Lawall <[email protected]>
Acked-by: Joachim Eastwood <[email protected]>
Signed-off-by: Linus Walleij <[email protected]>
|
|
i2c_smbus_write_byte_data() can fail. To ensure the
cached buffer has consistent status with h/w status, don't
update the cached gpio->buffer if write fails.
Also refactor the code a bit by adding a tpic2810_set_mask_bits()
helper and use it to simplify the code.
Signed-off-by: Axel Lin <[email protected]>
Reviewed-by: Alexandre Courbot <[email protected]>
Signed-off-by: Linus Walleij <[email protected]>
|
|
The .direction_output callback should set proper output level.
Signed-off-by: Axel Lin <[email protected]>
Signed-off-by: Linus Walleij <[email protected]>
|
|
Add driver for TI TPIC2810 8-Bit LED Driver with I2C Interface.
The TPIC2810 has 8 open-drain outputs that can but used to drive
LEDs and other low-side switched resistive loads.
Signed-off-by: Andrew F. Davis <[email protected]>
Signed-off-by: Linus Walleij <[email protected]>
|