diff options
Diffstat (limited to 'drivers/spi/spi-sprd.c')
| -rw-r--r-- | drivers/spi/spi-sprd.c | 17 |
1 files changed, 13 insertions, 4 deletions
diff --git a/drivers/spi/spi-sprd.c b/drivers/spi/spi-sprd.c index 8c9021b7f7a9..6678f1cbc566 100644 --- a/drivers/spi/spi-sprd.c +++ b/drivers/spi/spi-sprd.c @@ -669,12 +669,16 @@ static void sprd_spi_set_speed(struct sprd_spi *ss, u32 speed_hz) writel_relaxed(clk_div, ss->base + SPRD_SPI_CLKD); } -static void sprd_spi_init_hw(struct sprd_spi *ss, struct spi_transfer *t) +static int sprd_spi_init_hw(struct sprd_spi *ss, struct spi_transfer *t) { + struct spi_delay *d = &t->word_delay; u16 word_delay, interval; u32 val; - val = readl_relaxed(ss->base + SPRD_SPI_CTL7); + if (d->unit != SPI_DELAY_UNIT_SCK) + return -EINVAL; + + val = readl_relaxed(ss->base + SPRD_SPI_CTL0); val &= ~(SPRD_SPI_SCK_REV | SPRD_SPI_NG_TX | SPRD_SPI_NG_RX); /* Set default chip selection, clock phase and clock polarity */ val |= ss->hw_mode & SPI_CPHA ? SPRD_SPI_NG_RX : SPRD_SPI_NG_TX; @@ -686,7 +690,7 @@ static void sprd_spi_init_hw(struct sprd_spi *ss, struct spi_transfer *t) * formula as below per datasheet: * interval time (source clock cycles) = interval * 4 + 10. */ - word_delay = clamp_t(u16, t->word_delay, SPRD_SPI_MIN_DELAY_CYCLE, + word_delay = clamp_t(u16, d->value, SPRD_SPI_MIN_DELAY_CYCLE, SPRD_SPI_MAX_DELAY_CYCLE); interval = DIV_ROUND_UP(word_delay - 10, 4); ss->word_delay = interval * 4 + 10; @@ -711,6 +715,8 @@ static void sprd_spi_init_hw(struct sprd_spi *ss, struct spi_transfer *t) val &= ~SPRD_SPI_DATA_LINE2_EN; writel_relaxed(val, ss->base + SPRD_SPI_CTL7); + + return 0; } static int sprd_spi_setup_transfer(struct spi_device *sdev, @@ -719,13 +725,16 @@ static int sprd_spi_setup_transfer(struct spi_device *sdev, struct sprd_spi *ss = spi_controller_get_devdata(sdev->controller); u8 bits_per_word = t->bits_per_word; u32 val, mode = 0; + int ret; ss->len = t->len; ss->tx_buf = t->tx_buf; ss->rx_buf = t->rx_buf; ss->hw_mode = sdev->mode; - sprd_spi_init_hw(ss, t); + ret = sprd_spi_init_hw(ss, t); + if (ret) + return ret; /* Set tansfer speed and valid bits */ sprd_spi_set_speed(ss, t->speed_hz); |