5 files changed, 53 insertions, 4 deletions

diff --git a/drivers/net/phy/aquantia_main.c b/drivers/net/phy/aquantia_main.c
index a8db1a19011b..c7047f5d7a9b 100644
--- a/drivers/net/phy/aquantia_main.c
+++ b/drivers/net/phy/aquantia_main.c
@@ -34,6 +34,8 @@
 #define MDIO_AN_VEND_PROV			0xc400
 #define MDIO_AN_VEND_PROV_1000BASET_FULL	BIT(15)
 #define MDIO_AN_VEND_PROV_1000BASET_HALF	BIT(14)
+#define MDIO_AN_VEND_PROV_5000BASET_FULL	BIT(11)
+#define MDIO_AN_VEND_PROV_2500BASET_FULL	BIT(10)
 #define MDIO_AN_VEND_PROV_DOWNSHIFT_EN		BIT(4)
 #define MDIO_AN_VEND_PROV_DOWNSHIFT_MASK	GENMASK(3, 0)
 #define MDIO_AN_VEND_PROV_DOWNSHIFT_DFLT	4
@@ -231,9 +233,20 @@ static int aqr_config_aneg(struct phy_device *phydev)
 			      phydev->advertising))
 		reg |= MDIO_AN_VEND_PROV_1000BASET_HALF;
 
+	/* Handle the case when the 2.5G and 5G speeds are not advertised */
+	if (linkmode_test_bit(ETHTOOL_LINK_MODE_2500baseT_Full_BIT,
+			      phydev->advertising))
+		reg |= MDIO_AN_VEND_PROV_2500BASET_FULL;
+
+	if (linkmode_test_bit(ETHTOOL_LINK_MODE_5000baseT_Full_BIT,
+			      phydev->advertising))
+		reg |= MDIO_AN_VEND_PROV_5000BASET_FULL;
+
 	ret = phy_modify_mmd_changed(phydev, MDIO_MMD_AN, MDIO_AN_VEND_PROV,
 				     MDIO_AN_VEND_PROV_1000BASET_HALF |
-				     MDIO_AN_VEND_PROV_1000BASET_FULL, reg);
+				     MDIO_AN_VEND_PROV_1000BASET_FULL |
+				     MDIO_AN_VEND_PROV_2500BASET_FULL |
+				     MDIO_AN_VEND_PROV_5000BASET_FULL, reg);
 	if (ret < 0)
 		return ret;
 	if (ret > 0)
diff --git a/drivers/net/phy/at803x.c b/drivers/net/phy/at803x.c
index 6a467e7817a6..59fe356942b5 100644
--- a/drivers/net/phy/at803x.c
+++ b/drivers/net/phy/at803x.c
@@ -2072,6 +2072,8 @@ static struct phy_driver at803x_driver[] = {
 	/* ATHEROS AR9331 */
 	PHY_ID_MATCH_EXACT(ATH9331_PHY_ID),
 	.name			= "Qualcomm Atheros AR9331 built-in PHY",
+	.probe			= at803x_probe,
+	.remove			= at803x_remove,
 	.suspend		= at803x_suspend,
 	.resume			= at803x_resume,
 	.flags			= PHY_POLL_CABLE_TEST,
@@ -2087,6 +2089,8 @@ static struct phy_driver at803x_driver[] = {
 	/* Qualcomm Atheros QCA9561 */
 	PHY_ID_MATCH_EXACT(QCA9561_PHY_ID),
 	.name			= "Qualcomm Atheros QCA9561 built-in PHY",
+	.probe			= at803x_probe,
+	.remove			= at803x_remove,
 	.suspend		= at803x_suspend,
 	.resume			= at803x_resume,
 	.flags			= PHY_POLL_CABLE_TEST,
@@ -2151,6 +2155,8 @@ static struct phy_driver at803x_driver[] = {
 	PHY_ID_MATCH_EXACT(QCA8081_PHY_ID),
 	.name			= "Qualcomm QCA8081",
 	.flags			= PHY_POLL_CABLE_TEST,
+	.probe			= at803x_probe,
+	.remove			= at803x_remove,
 	.config_intr		= at803x_config_intr,
 	.handle_interrupt	= at803x_handle_interrupt,
 	.get_tunable		= at803x_get_tunable,
diff --git a/drivers/net/phy/dp83867.c b/drivers/net/phy/dp83867.c
index 8561f2d4443b..13dafe7a29bd 100644
--- a/drivers/net/phy/dp83867.c
+++ b/drivers/net/phy/dp83867.c
@@ -137,6 +137,7 @@
 #define DP83867_DOWNSHIFT_2_COUNT	2
 #define DP83867_DOWNSHIFT_4_COUNT	4
 #define DP83867_DOWNSHIFT_8_COUNT	8
+#define DP83867_SGMII_AUTONEG_EN	BIT(7)
 
 /* CFG3 bits */
 #define DP83867_CFG3_INT_OE			BIT(7)
@@ -855,6 +856,32 @@ static int dp83867_phy_reset(struct phy_device *phydev)
 			 DP83867_PHYCR_FORCE_LINK_GOOD, 0);
 }
 
+static void dp83867_link_change_notify(struct phy_device *phydev)
+{
+	/* There is a limitation in DP83867 PHY device where SGMII AN is
+	 * only triggered once after the device is booted up. Even after the
+	 * PHY TPI is down and up again, SGMII AN is not triggered and
+	 * hence no new in-band message from PHY to MAC side SGMII.
+	 * This could cause an issue during power up, when PHY is up prior
+	 * to MAC. At this condition, once MAC side SGMII is up, MAC side
+	 * SGMII wouldn`t receive new in-band message from TI PHY with
+	 * correct link status, speed and duplex info.
+	 * Thus, implemented a SW solution here to retrigger SGMII Auto-Neg
+	 * whenever there is a link change.
+	 */
+	if (phydev->interface == PHY_INTERFACE_MODE_SGMII) {
+		int val = 0;
+
+		val = phy_clear_bits(phydev, DP83867_CFG2,
+				     DP83867_SGMII_AUTONEG_EN);
+		if (val < 0)
+			return;
+
+		phy_set_bits(phydev, DP83867_CFG2,
+			     DP83867_SGMII_AUTONEG_EN);
+	}
+}
+
 static struct phy_driver dp83867_driver[] = {
 	{
 		.phy_id		= DP83867_PHY_ID,
@@ -879,6 +906,8 @@ static struct phy_driver dp83867_driver[] = {
 
 		.suspend	= genphy_suspend,
 		.resume		= genphy_resume,
+
+		.link_change_notify = dp83867_link_change_notify,
 	},
 };
 module_phy_driver(dp83867_driver);
diff --git a/drivers/net/phy/mdio_bus.c b/drivers/net/phy/mdio_bus.c
index 58d602985877..8a2dbe849866 100644
--- a/drivers/net/phy/mdio_bus.c
+++ b/drivers/net/phy/mdio_bus.c
@@ -1046,7 +1046,6 @@ int __init mdio_bus_init(void)
 
 	return ret;
 }
-EXPORT_SYMBOL_GPL(mdio_bus_init);
 
 #if IS_ENABLED(CONFIG_PHYLIB)
 void mdio_bus_exit(void)
diff --git a/drivers/net/phy/smsc.c b/drivers/net/phy/smsc.c
index 1b54684b68a0..96d3c40932d8 100644
--- a/drivers/net/phy/smsc.c
+++ b/drivers/net/phy/smsc.c
@@ -110,7 +110,7 @@ static int smsc_phy_config_init(struct phy_device *phydev)
 	struct smsc_phy_priv *priv = phydev->priv;
 	int rc;
 
-	if (!priv->energy_enable)
+	if (!priv->energy_enable || phydev->irq != PHY_POLL)
 		return 0;
 
 	rc = phy_read(phydev, MII_LAN83C185_CTRL_STATUS);
@@ -210,6 +210,8 @@ static int lan95xx_config_aneg_ext(struct phy_device *phydev)
  * response on link pulses to detect presence of plugged Ethernet cable.
  * The Energy Detect Power-Down mode is enabled again in the end of procedure to
  * save approximately 220 mW of power if cable is unplugged.
+ * The workaround is only applicable to poll mode. Energy Detect Power-Down may
+ * not be used in interrupt mode lest link change detection becomes unreliable.
  */
 static int lan87xx_read_status(struct phy_device *phydev)
 {
@@ -217,7 +219,7 @@ static int lan87xx_read_status(struct phy_device *phydev)
 
 	int err = genphy_read_status(phydev);
 
-	if (!phydev->link && priv->energy_enable) {
+	if (!phydev->link && priv->energy_enable && phydev->irq == PHY_POLL) {
 		/* Disable EDPD to wake up PHY */
 		int rc = phy_read(phydev, MII_LAN83C185_CTRL_STATUS);
 		if (rc < 0)