diff options
Diffstat (limited to 'drivers/mmc/host/mmc_spi.c')
| -rw-r--r-- | drivers/mmc/host/mmc_spi.c | 36 |
1 files changed, 17 insertions, 19 deletions
diff --git a/drivers/mmc/host/mmc_spi.c b/drivers/mmc/host/mmc_spi.c index b8dda8160c4e..09d7a6a0dc1a 100644 --- a/drivers/mmc/host/mmc_spi.c +++ b/drivers/mmc/host/mmc_spi.c @@ -15,7 +15,6 @@ #include <linux/slab.h> #include <linux/module.h> #include <linux/bio.h> -#include <linux/dma-direction.h> #include <linux/crc7.h> #include <linux/crc-itu-t.h> #include <linux/scatterlist.h> @@ -510,10 +509,7 @@ mmc_spi_command_send(struct mmc_spi_host *host, * so we explicitly initialize it to all ones on RX paths. */ static void -mmc_spi_setup_data_message( - struct mmc_spi_host *host, - bool multiple, - enum dma_data_direction direction) +mmc_spi_setup_data_message(struct mmc_spi_host *host, bool multiple, bool write) { struct spi_transfer *t; struct scratch *scratch = host->data; @@ -523,7 +519,7 @@ mmc_spi_setup_data_message( /* for reads, readblock() skips 0xff bytes before finding * the token; for writes, this transfer issues that token. */ - if (direction == DMA_TO_DEVICE) { + if (write) { t = &host->token; memset(t, 0, sizeof(*t)); t->len = 1; @@ -547,7 +543,7 @@ mmc_spi_setup_data_message( t = &host->crc; memset(t, 0, sizeof(*t)); t->len = 2; - if (direction == DMA_TO_DEVICE) { + if (write) { /* the actual CRC may get written later */ t->tx_buf = &scratch->crc_val; } else { @@ -570,10 +566,10 @@ mmc_spi_setup_data_message( * the next token (next data block, or STOP_TRAN). We can try to * minimize I/O ops by using a single read to collect end-of-busy. */ - if (multiple || direction == DMA_TO_DEVICE) { + if (multiple || write) { t = &host->early_status; memset(t, 0, sizeof(*t)); - t->len = (direction == DMA_TO_DEVICE) ? sizeof(scratch->status) : 1; + t->len = write ? sizeof(scratch->status) : 1; t->tx_buf = host->ones; t->rx_buf = scratch->status; t->cs_change = 1; @@ -777,15 +773,15 @@ mmc_spi_data_do(struct mmc_spi_host *host, struct mmc_command *cmd, { struct spi_device *spi = host->spi; struct spi_transfer *t; - enum dma_data_direction direction = mmc_get_dma_dir(data); struct scatterlist *sg; unsigned n_sg; bool multiple = (data->blocks > 1); - const char *write_or_read = (direction == DMA_TO_DEVICE) ? "write" : "read"; + bool write = (data->flags & MMC_DATA_WRITE); + const char *write_or_read = write ? "write" : "read"; u32 clock_rate; unsigned long timeout; - mmc_spi_setup_data_message(host, multiple, direction); + mmc_spi_setup_data_message(host, multiple, write); t = &host->t; if (t->speed_hz) @@ -807,7 +803,7 @@ mmc_spi_data_do(struct mmc_spi_host *host, struct mmc_command *cmd, /* allow pio too; we don't allow highmem */ kmap_addr = kmap(sg_page(sg)); - if (direction == DMA_TO_DEVICE) + if (write) t->tx_buf = kmap_addr + sg->offset; else t->rx_buf = kmap_addr + sg->offset; @@ -818,7 +814,7 @@ mmc_spi_data_do(struct mmc_spi_host *host, struct mmc_command *cmd, dev_dbg(&spi->dev, " %s block, %d bytes\n", write_or_read, t->len); - if (direction == DMA_TO_DEVICE) + if (write) status = mmc_spi_writeblock(host, t, timeout); else status = mmc_spi_readblock(host, t, timeout); @@ -833,7 +829,9 @@ mmc_spi_data_do(struct mmc_spi_host *host, struct mmc_command *cmd, } /* discard mappings */ - if (direction == DMA_FROM_DEVICE) + if (write) + /* nothing to do */; + else flush_dcache_page(sg_page(sg)); kunmap(sg_page(sg)); @@ -850,7 +848,7 @@ mmc_spi_data_do(struct mmc_spi_host *host, struct mmc_command *cmd, * that can affect the STOP_TRAN logic. Complete (and current) * MMC specs should sort that out before Linux starts using CMD23. */ - if (direction == DMA_TO_DEVICE && multiple) { + if (write && multiple) { struct scratch *scratch = host->data; int tmp; const unsigned statlen = sizeof(scratch->status); @@ -935,7 +933,7 @@ static void mmc_spi_request(struct mmc_host *mmc, struct mmc_request *mrq) #endif /* request exclusive bus access */ - spi_bus_lock(host->spi->master); + spi_bus_lock(host->spi->controller); crc_recover: /* issue command; then optionally data and stop */ @@ -967,7 +965,7 @@ crc_recover: } /* release the bus */ - spi_bus_unlock(host->spi->master); + spi_bus_unlock(host->spi->controller); mmc_request_done(host->mmc, mrq); } @@ -1157,7 +1155,7 @@ static int mmc_spi_probe(struct spi_device *spi) /* We rely on full duplex transfers, mostly to reduce * per-transfer overheads (by making fewer transfers). */ - if (spi->master->flags & SPI_CONTROLLER_HALF_DUPLEX) + if (spi->controller->flags & SPI_CONTROLLER_HALF_DUPLEX) return -EINVAL; /* MMC and SD specs only seem to care that sampling is on the |