Merge tag 'spi-nor/for-5.19' into mtd/next

SPI NOR core changes:
- Read back written SR value to make sure the write was done correctly.
- Introduce a common function for Read ID that manufacturer drivers can
  use to verify the Octal DTR switch worked correctly.
- Add helpers for read/write any register commands so manufacturer
  drivers don't open code it every time.
- Clarify rdsr dummy cycles documentation.
- Add debugfs entry to expose internal flash parameters and state.

SPI NOR manufacturer drivers changes:
- Add support for Winbond W25Q512NW-IM, and Eon EN25QH256A.
- Move spi_nor_write_ear() to Winbond module since only Winbond flashes
  use it.
- Rework Micron and Cypress Octal DTR enable methods to improve
  readability.
- Use the common Read ID function to verify switch to Octal DTR mode for
  Micron and Cypress flashes.
- Skip polling status on volatile register writes for Micron and Cypress
  flashes since the operation is instant.

Signed-off-by: Miquel Raynal <[email protected]>

1 files changed, 3 insertions, 2 deletions

diff --git a/drivers/mmc/core/core.c b/drivers/mmc/core/core.c
index 368f10405e13..c6ae16d40766 100644
--- a/drivers/mmc/core/core.c
+++ b/drivers/mmc/core/core.c
@@ -1995,7 +1995,7 @@ static void mmc_hw_reset_for_init(struct mmc_host *host)
 
 /**
  * mmc_hw_reset - reset the card in hardware
- * @host: MMC host to which the card is attached
+ * @card: card to be reset
  *
  * Hard reset the card. This function is only for upper layers, like the
  * block layer or card drivers. You cannot use it in host drivers (struct
@@ -2003,8 +2003,9 @@ static void mmc_hw_reset_for_init(struct mmc_host *host)
  *
  * Return: 0 on success, -errno on failure
  */
-int mmc_hw_reset(struct mmc_host *host)
+int mmc_hw_reset(struct mmc_card *card)
 {
+	struct mmc_host *host = card->host;
 	int ret;
 
 	ret = host->bus_ops->hw_reset(host);