Merge tag 'spi-nor/for-5.19' into mtd/next

SPI NOR core changes:
- Read back written SR value to make sure the write was done correctly.
- Introduce a common function for Read ID that manufacturer drivers can
  use to verify the Octal DTR switch worked correctly.
- Add helpers for read/write any register commands so manufacturer
  drivers don't open code it every time.
- Clarify rdsr dummy cycles documentation.
- Add debugfs entry to expose internal flash parameters and state.

SPI NOR manufacturer drivers changes:
- Add support for Winbond W25Q512NW-IM, and Eon EN25QH256A.
- Move spi_nor_write_ear() to Winbond module since only Winbond flashes
  use it.
- Rework Micron and Cypress Octal DTR enable methods to improve
  readability.
- Use the common Read ID function to verify switch to Octal DTR mode for
  Micron and Cypress flashes.
- Skip polling status on volatile register writes for Micron and Cypress
  flashes since the operation is instant.

Signed-off-by: Miquel Raynal <[email protected]>

1 files changed, 2 insertions, 4 deletions

diff --git a/drivers/i2c/busses/i2c-qcom-geni.c b/drivers/i2c/busses/i2c-qcom-geni.c
index fc1dcc19f2a1..5b920f0fc7dd 100644
--- a/drivers/i2c/busses/i2c-qcom-geni.c
+++ b/drivers/i2c/busses/i2c-qcom-geni.c
@@ -843,10 +843,8 @@ static int geni_i2c_probe(struct platform_device *pdev)
 		/* FIFO is disabled, so we can only use GPI DMA */
 		gi2c->gpi_mode = true;
 		ret = setup_gpi_dma(gi2c);
-		if (ret) {
-			dev_err(dev, "Failed to setup GPI DMA mode:%d ret\n", ret);
-			return ret;
-		}
+		if (ret)
+			return dev_err_probe(dev, ret, "Failed to setup GPI DMA mode\n");
 
 		dev_dbg(dev, "Using GPI DMA mode for I2C\n");
 	} else {