blaster4385/linux-IllusionX/drivers/i2c, branch v6.12.10

i2c: microchip-core: fix "ghost" detections

2025-01-02T09:34:23Z

commit 49e1f0fd0d4cb03a16b8526c4e683e1958f71490 upstream. Running i2c-detect currently produces an output akin to: 0 1 2 3 4 5 6 7 8 9 a b c d e f 00: 08 -- 0a -- 0c -- 0e -- 10: 10 -- 12 -- 14 -- 16 -- UU 19 -- 1b -- 1d -- 1f 20: -- 21 -- 23 -- 25 -- 27 -- 29 -- 2b -- 2d -- 2f 30: -- -- -- -- -- -- -- -- 38 -- 3a -- 3c -- 3e -- 40: 40 -- 42 -- 44 -- 46 -- 48 -- 4a -- 4c -- 4e -- 50: -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- 60: 60 -- 62 -- 64 -- 66 -- 68 -- 6a -- 6c -- 6e -- 70: 70 -- 72 -- 74 -- 76 -- This happens because for an i2c_msg with a len of 0 the driver will mark the transmission of the message as a success once the START has been sent, without waiting for the devices on the bus to respond with an ACK/NAK. Since i2cdetect seems to run in a tight loop over all addresses the NAK is treated as part of the next test for the next address. Delete the fast path that marks a message as complete when idev->msg_len is zero after sending a START/RESTART since this isn't a valid scenario. CC: stable@vger.kernel.org Fixes: 64a6f1c4987e ("i2c: add support for microchip fpga i2c controllers") Signed-off-by: Conor Dooley Reviewed-by: Andi Shyti Link: https://lore.kernel.org/r/20241218-outbid-encounter-b2e78b1cc707@spud Signed-off-by: Andi Shyti Signed-off-by: Greg Kroah-Hartman

i2c: imx: add imx7d compatible string for applying erratum ERR007805

2025-01-02T09:34:23Z

commit e0cec363197e41af870613e8e17b30bf0e3d41b5 upstream. Compatible string "fsl,imx7d-i2c" is not exited at i2c-imx driver compatible string table, at the result, "fsl,imx21-i2c" will be matched, but it will cause erratum ERR007805 not be applied in fact. So Add "fsl,imx7d-i2c" compatible string in i2c-imx driver to apply the erratum ERR007805(https://www.nxp.com/docs/en/errata/IMX7DS_3N09P.pdf). " ERR007805 I2C: When the I2C clock speed is configured for 400 kHz, the SCL low period violates the I2C spec of 1.3 uS min Description: When the I2C module is programmed to operate at the maximum clock speed of 400 kHz (as defined by the I2C spec), the SCL clock low period violates the I2C spec of 1.3 uS min. The user must reduce the clock speed to obtain the SCL low time to meet the 1.3us I2C minimum required. This behavior means the SoC is not compliant to the I2C spec at 400kHz. Workaround: To meet the clock low period requirement in fast speed mode, SCL must be configured to 384KHz or less. " "fsl,imx7d-i2c" already is documented in binding doc. This erratum fix has been included in imx6_i2c_hwdata and it is the same in all I.MX6/7/8, so just reuse it. Fixes: 39c025721d70 ("i2c: imx: Implement errata ERR007805 or e7805 bus frequency limit") Cc: stable@vger.kernel.org # v5.18+ Signed-off-by: Carlos Song Signed-off-by: Haibo Chen Reviewed-by: Frank Li Fixes: 39c025721d70 ("i2c: imx: Implement errata ERR007805 or e7805 bus frequency limit") Acked-by: Oleksij Rempel Link: https://lore.kernel.org/r/20241218044238.143414-1-carlos.song@nxp.com Signed-off-by: Andi Shyti Signed-off-by: Greg Kroah-Hartman

i2c: microchip-core: actually use repeated sends

2025-01-02T09:34:22Z

commit 9a8f9320d67b27ddd7f1ee88d91820197a0e908f upstream. At present, where repeated sends are intended to be used, the i2c-microchip-core driver sends a stop followed by a start. Lots of i2c devices must not malfunction in the face of this behaviour, because the driver has operated like this for years! Try to keep track of whether or not a repeated send is required, and suppress sending a stop in these cases. CC: stable@vger.kernel.org Fixes: 64a6f1c4987e ("i2c: add support for microchip fpga i2c controllers") Signed-off-by: Conor Dooley Reviewed-by: Andi Shyti Link: https://lore.kernel.org/r/20241218-football-composure-e56df2461461@spud Signed-off-by: Andi Shyti Signed-off-by: Greg Kroah-Hartman

i2c: riic: Always round-up when calculating bus period

2024-12-27T13:02:07Z

commit de6b43798d9043a7c749a0428dbb02d5fff156e5 upstream. Currently, the RIIC driver may run the I2C bus faster than requested, which may cause subtle failures. E.g. Biju reported a measured bus speed of 450 kHz instead of the expected maximum of 400 kHz on RZ/G2L. The initial calculation of the bus period uses DIV_ROUND_UP(), to make sure the actual bus speed never becomes faster than the requested bus speed. However, the subsequent division-by-two steps do not use round-up, which may lead to a too-small period, hence a too-fast and possible out-of-spec bus speed. E.g. on RZ/Five, requesting a bus speed of 100 resp. 400 kHz will yield too-fast target bus speeds of 100806 resp. 403226 Hz instead of 97656 resp. 390625 Hz. Fix this by using DIV_ROUND_UP() in the subsequent divisions, too. Tested on RZ/A1H, RZ/A2M, and RZ/Five. Fixes: d982d66514192cdb ("i2c: riic: remove clock and frequency restrictions") Reported-by: Biju Das Signed-off-by: Geert Uytterhoeven Cc: # v4.15+ Link: https://lore.kernel.org/r/c59aea77998dfea1b4456c4b33b55ab216fcbf5e.1732284746.git.geert+renesas@glider.be Signed-off-by: Andi Shyti Signed-off-by: Greg Kroah-Hartman

i2c: pnx: Fix timeout in wait functions

2024-12-27T13:01:59Z

[ Upstream commit 7363f2d4c18557c99c536b70489187bb4e05c412 ] Since commit f63b94be6942 ("i2c: pnx: Fix potential deadlock warning from del_timer_sync() call in isr") jiffies are stored in i2c_pnx_algo_data.timeout, but wait_timeout and wait_reset are still using it as milliseconds. Convert jiffies back to milliseconds to wait for the expected amount of time. Fixes: f63b94be6942 ("i2c: pnx: Fix potential deadlock warning from del_timer_sync() call in isr") Signed-off-by: Vladimir Riabchun Signed-off-by: Andi Shyti Signed-off-by: Sasha Levin

i2c: i801: Add support for Intel Panther Lake

2024-12-14T19:03:55Z

[ Upstream commit bd492b58371295d3ae26162b9666be584abad68a ] Add SMBus PCI IDs on Intel Panther Lake-P and -U. Signed-off-by: Jarkko Nikula Signed-off-by: Andi Shyti Signed-off-by: Sasha Levin

i2c: dev: Fix memory leak when underlying adapter does not support I2C

2024-12-05T13:01:58Z

[ Upstream commit 48730a9d04ffccda541602d722d1ff81920a85d8 ] Early return in i2cdev_ioctl_rdwr() failed to free the memory allocated by the caller. Move freeing the memory to the function where it has been allocated to prevent similar leaks in the future. Fixes: 97ca843f6ad3 ("i2c: dev: Check for I2C_FUNC_I2C before calling i2c_transfer") Signed-off-by: Igor Pylypiv [wsa: replaced '== NULL' with '!'] Signed-off-by: Wolfram Sang Signed-off-by: Sasha Levin

i2c: designware: do not hold SCL low when I2C_DYNAMIC_TAR_UPDATE is not set

2024-11-08T18:13:06Z

When the Tx FIFO is empty and the last command has no STOP bit set, the master holds SCL low. If I2C_DYNAMIC_TAR_UPDATE is not set, BIT(13) MST_ON_HOLD of IC_RAW_INTR_STAT is not enabled, causing the __i2c_dw_disable() timeout. This is quite similar to commit 2409205acd3c ("i2c: designware: fix __i2c_dw_disable() in case master is holding SCL low"). Also check BIT(7) MST_HOLD_TX_FIFO_EMPTY in IC_STATUS, which is available when IC_STAT_FOR_CLK_STRETCH is set. Fixes: 2409205acd3c ("i2c: designware: fix __i2c_dw_disable() in case master is holding SCL low") Co-developed-by: Xiaowu Ding Signed-off-by: Xiaowu Ding Co-developed-by: Angus Chen Signed-off-by: Angus Chen Signed-off-by: Liu Peibao Acked-by: Jarkko Nikula Signed-off-by: Andi Shyti

i2c: muxes: Fix return value check in mule_i2c_mux_probe()

2024-11-05T14:17:34Z

If dev_get_regmap() fails, it returns NULL pointer not ERR_PTR(), replace IS_ERR() with NULL pointer check, and return -ENODEV. Fixes: d0f8e97866bf ("i2c: muxes: add support for tsd,mule-i2c multiplexer") Signed-off-by: Yang Yingliang Signed-off-by: Andi Shyti

Merge tag 'i2c-for-6.12-rc2' of git://git.kernel.org/pub/scm/linux/kernel/git/wsa/linux

2024-10-05T17:31:04Z

Pull i2c fix from Wolfram Sang: - Fix potential deadlock during runtime suspend and resume (stm32f7) * tag 'i2c-for-6.12-rc2' of git://git.kernel.org/pub/scm/linux/kernel/git/wsa/linux: i2c: stm32f7: Do not prepare/unprepare clock during runtime suspend/resume