f10378fff6
Changes: - Added Bus-OSM which could be used by user space programs to reset a channel on the controller - Make ioctl's in Config-OSM obsolete in prefer for sysfs attributes and move those to its own file - Added sysfs attribute for firmware read and write access for I2O controllers - Added special handling of firmware read and write access for Adaptec controllers - Added vendor id and product id as sysfs-attribute to Executive classes - Added automatic notification of LCT change handling to Exec-OSM - Added flushing function to Block-OSM for later barrier implementation - Use PRIVATE messages for Block access on Adaptec controllers, which are faster then BLOCK class access - Cleaned up support for Promise controller - New messages are now detected using the IRQ status register as suggested by the I2O spec - Added i2o_dma_high() and i2o_dma_low() functions - Added facility for SG tablesize calculation when using 32-bit and 64-bit DMA addresses - Added i2o_dma_map_single() and i2o_dma_map_sg() which could build the SG list for 32-bit as well as 64-bit DMA addresses Signed-off-by: Markus Lidel <Markus.Lidel@shadowconnect.com> Signed-off-by: Andrew Morton <akpm@osdl.org> Signed-off-by: Linus Torvalds <torvalds@osdl.org>
16 lines
507 B
Makefile
16 lines
507 B
Makefile
#
|
|
# Makefile for the kernel I2O OSM.
|
|
#
|
|
# Note : at this point, these files are compiled on all systems.
|
|
# In the future, some of these should be built conditionally.
|
|
#
|
|
|
|
i2o_core-y += iop.o driver.o device.o debug.o pci.o exec-osm.o
|
|
i2o_bus-y += bus-osm.o
|
|
i2o_config-y += config-osm.o
|
|
obj-$(CONFIG_I2O) += i2o_core.o
|
|
obj-$(CONFIG_I2O_CONFIG)+= i2o_config.o
|
|
obj-$(CONFIG_I2O_BUS) += i2o_bus.o
|
|
obj-$(CONFIG_I2O_BLOCK) += i2o_block.o
|
|
obj-$(CONFIG_I2O_SCSI) += i2o_scsi.o
|
|
obj-$(CONFIG_I2O_PROC) += i2o_proc.o
|