The ASP1 DOUT line must be defaulted to be high-impedance when
it is not actually transmitting data for an active channel.
In non-SoundWire modes ASP1 will usually be shared by multiple
amps so each amp must only drive the line during the slot for
an enabled TX channel.
In SoundWire mode a custom firmware can use ASP1 as a secondary
chip-to-chip audio link or as GPIO. It should be defaulted to
high-impedance since by default the purpose of this pin is not
known.
Backport note:
On kernel versions before 6.6 the cs35l56->base.regmap argument
to regmap_set_bits() must be changed to cs35l56->regmap.
Signed-off-by: Richard Fitzgerald <rf@opensource.cirrus.com>
Fixes: e496112529 ("ASoC: cs35l56: Add driver for Cirrus Logic CS35L56")
Link: https://lore.kernel.org/r/20231009153412.30380-1-rf@opensource.cirrus.com
Signed-off-by: Mark Brown <broonie@kernel.org>
1bba0badff